American access system ADV-1000 Podręcznik Użytkownika Pobierz pdf (Strona 426)

100

101

426 WIN-PAK User Guide

5 Enter a value in the Shunt Time field to set the

amount of time that the output point is ener-

gized when triggered. The field defaults to zero,

but can be set from 0 to 63 seconds, 0 to 63

minutes, 0 to 63 hours.

6 The Mode list offers three choices: Normal,

Latching, and Non-Latching. Latching is the

manual use of electronic access control creden-

tials in which one credential read causes a lock to

unlock and a second read locks the lock. The

lock changes state only after a credential is read.

Following are descriptions of each Mode.

Mode Descriptions

Normal

The input acts normally, reporting alarms, normals, and troubles.

Non-Latching

Entry: A door is set up as an input point, with an entry delay of 10 seconds. If the door

remains open more than 10 seconds, it is reported.

Exit: The exit delay is the amount of time a contact can be unshunted (unmasked) before

being reported. (Similar to a pulse time).

Latching

Entry: If a door [set up as an input point, with an entry delay of 10 seconds] is opened,

the user has 10 seconds to shunt the point, otherwise it will report as an alarm. Even if the

point returns to normal before the entry delay time runs out, if the point has not been

shunted (masked), it will report as an alarm.

Exit: The exit delay is the amount of time a contact can be unshunted [unmasked] before

being reported. (Similar to a pulse time.)

7 The Entry Delay is the amount of time an input

point can remain open before an alarm is acti-

vated. This field defaults to zero seconds, but

can be set up to 255 seconds.

8 Exit Delay is the amount of time a point can be

unshunted (unmasked) before being reported as

an alarm. This field defaults to zero seconds, but

can be set up to 255 seconds.

NOTE: Entry and Exit Delay fields are not available if

1 2 ... 421 422 423 424 425 426 427 428 429 430 431 ... 776 777

Komentarze do niniejszej Instrukcji

Brak uwag

American access system ADV-1000 Podręcznik Użytkownika Strona 426

Komentarze do niniejszej Instrukcji